Login / Register
Change Your Country

Training and DOT BAT Procedures FAQ

Question ID:
 473

Intoximeters, Inc. does not claim to be an expert on infectious disease transmission, but it has developed two guides (Infection Control Cleaning and Disinfecting Intoximeters Handheld Instruments and Infection Control Cleaning and Disinfecting an Intoximeters Desktop Instrument)  that list some of the concerns and commonsense steps that can be taken to reduce the likelihood of disease transmission while performing a breath alcohol test or while cleaning or disinfecting an Intoximeters, Inc. alcohol breath test instrument.

Additional information and directives on Coronavirus can be found through OSHA (3990-03 2020) or the CDC. The CDC has put out documentation for the maintenance on other types of breathing related equipment such as spirometers that may have helpful information on infections control measures.

Question ID:
 492
Section:
 ECIR

It means that either an accuracy check, or a calibration followed by an accuracy check must be performed before further subject testing can occur.

Please note that in the U.S. Department of Transportation workplace testing program the device can only be calibrated by the manufacturer or someone certified by the manufacturer.  If you have questions about whether or not you are authorized to perform a calibration, please contact the Training Department.

Categories: EC/IR, Technical
Question ID:
 501
Link Title:
 E-mail Technical Support
Link:
Section:
 ECIR

This display means that the Intox EC/IR is not detecting an appropriate flow of gas from the standard.  Check to make sure a gas standard is connected. If you are using a wet standard make sure the head of the simulator is properly attached.  If you are using a dry gas standard make sure the tank is not empty.

Categories: EC/IR, Technical
Question ID:
 529
Section:
 ECIR

Insufficient sample is a message that occurs if a subject does not provide a consistent breath sample.  The subject cannot stop blowing before the instrument takes a sample – make sure he or she understands your instructions.

If the instrument displays this message even when a consistent sample is submitted, contact Intoximeters technical support for assistance.

Categories: EC/IR, Technical
Question ID:
 509
Section:
 ECIR

Check the internal printer to see if the ON LINE light is illuminated.  If not, press the On Line button.  Check to make certain the printer door is latched properly.  Check to see if there is paper in the printer.

If the printer is putting out blank paper, then it is likely that the thermal paper roll is installed backwards.  Check to make sure the paper roll is inserted so that the paper comes out over the top of the roll, not from underneath the roll.

If using an external printer, check the cable connection on the rear of the Intox EC/IR and make sure it is attached on both ends.  Check to make sure there is paper in the printer and it is turned on and ready to print.

Categories: EC/IR, Technical
Question ID:
 516
Section:
 ECIR

The memory is full and no more test data can be stored until the memory is erased.  Some agencies require downloading the test records prior to erasing the data.  Please check with your administrator before erasing the data.

Categories: EC/IR, Technical
Question ID:
 523

One condition that is required prior to testing is that key components are within predefined temperature ranges. If you have the proper password access to the F9 functions you can check the current operating temperatures of these components and identify which is out of range.

Generally, “REGULATING TEMP” is only displayed for a short time, perhaps 20 – 30 minutes if the instrument has been turned off.  If this display continues after a reasonable warm-up period, you should contact Technical Support for assistance.

Categories: EC/IR, Technical
Question ID:
 532
Link Title:
 Purchase Mouthpieces
Link:
Section:
 ECIR

Currently manufactured Intox EC/IRs are setup to work with the Checktrap mouthpiece (part# 23-0010-00) or the ASIV/ECIR one way mouthpiece (part# 23-0000-00)

Categories: EC/IR, Technical

Load More

FAQ Categories


0

Your Cart